Installation |
|
BabyBumper.com LLC |
Place the BabyBumper directly on the mattress and cover with a mattress pad and fitted sheet, then make the bed in a normal fashion using existing bedding. Each BabyBumper should be laid lengthwise approximately 4” from any exposed side of the bed and approximately a foot down from the headboard. See diagrams:
If your mattress has a plastic water resistant cover, place the BabyBumper between the mattress pad and fitted sheet to prevent the devices from slipping during use. The BabyBumper grips well to most surfaces but please check to ensure the devices won’t shift once installed. If your existing fitted sheet is too snug to cover the devices and won’t completely fit firmly over the sides of the mattress, please use a deep pocket fitted sheet to anchor the BabyBumper properly.
|
|
|
If your mattress has a plastic water resistant cover, place the BabyBumper between the mattress pad and fitted sheet to prevent the devices from slipping during use. The BabyBumper grips well to most surfaces but please check to ensure the devices won’t shift once installed. If your existing fitted sheet is too snug to cover the devices and won’t completely fit firmly over the sides of the mattress, please use a deep pocket fitted sheet to anchor the BabyBumper properly.
WARNING: Failure to follow all of the recommended installation and maintenance procedures may result in failure of the devices and could result in injury. Do not use the BabyBumper near windows, lofts, stairs, water features or any other structures or obstacles which may cause harm to the child.
Content copyright . BabyBumper.com LLC. All rights reserved.
